Hello I was going to upgrade a 200B firewall this evening at one of our
branch offices. Going from v4.3.12 to v5.2.6This is a single firewall
that was at one time part of an active-passive HA pair. The slave had
been removed a while ago but The HA co...
Hello I have a Fortigate 60B that needs to have SPI disabled as part of
a test. Are these the right commands in CLI to make that happen: config
system settings set asymroute enable end Also, If you enter this
command, what kind of impact would it hav...
Hi Everyone We had two New Fortigate 300Cs come into a remote office.
Someone locally got them both set up on a network there and I could
configure them remotely from a different office. Configured the pair in
HA. Everything was fine until I realized...
Hello I was notified this morning that there was a certain website that
could no longer be accessed and a screenshot sent by a user showed this
message: Web Page Blocked An error occurred while trying to rate the
website using the webfiltering servic...
Hi Everyone I have a Fortigate 200B (v4MR2P8). I have two internet
circuits(VZ ethernet/VZ Fios). I had previously set up several static
routes to send certain traffic over the VZ Fios circuit. The other day,
that circuit went down so I deleted all t...
Thanks for the feedback. I immediately enabled the workaround to prevent
any other similar issues. I did ' Test Availability' and was able to
reach the server. There are no licenses expired. They all expire in Oct.
2014. The DNS is fine but the time ...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
