So, I have a bit of a dilemma, this is the fact that the
Fortiauthenticator does a good job in authenticating and all and I am
trying to increase the OTP possibilities by introducing the chained
authentiaction from the same radius source. I have a Ra...
I cannot for the world get the push notifications to work, it is if the
Authenticator is not trying to send any out. - FortiAuthenticator
interface available from the Mobile device, check (not seeing any
requests come this way though)- Radius client ...
I imagine you have full control over your linux environment and you are
not really asking on the fortigate side of things. The guide is good for
getting the tunnels running, but not forcing traffic through the actual
tunnels. What we had to do was cr...
It is very possible that the client is not really responding to your DPD
messages, and thus the Fortigate tears down the connection as it is not
getting a response. Often because the client is in a low‑power state,
behind a NAT that drops UDP 4500, o...
Hi, You are not really giving a complete picture, how are routes added,
bgp or static, is the internet part of the sd-wan overlay etc? A few
thoughts. diagnose sys sdwan health-check on the hub- Confirms that the
health‑check for WAN 1 is actually fa...
The “replacement block page” is only shown when FortiGate can actually
inject its own HTML page into the HTTP response stream.In practice that
happens for attachment‑type downloads (e.g., ZIP files) but not for
content that the browser is expected to...
Are you running the webhook service? How are you configuring the webhook
alert? there are a lot of things that could go wrong and it is very
unforgiving
