Hey guys, I have tried 3 different computers with no change.
Fortiexplorer will attempt to launch once clicked on however nothing
happens. I have tried being plugged into the fortigate and without and
am met with the same result. I have also done the...
Hey Guy's, I am noticing consistent attempts to log into our device from
our wan link (shown by the alert message console widget). I have not
been able to figure out how to drill down and look at the IP that is
trying to gain access. Any help would b...
This is a new implementation. We have a fiber 10G handoff rate limited
to 1G which we have connected to a 10G port on a cisco switch which is
then connected to the fortinet device. The attached image will give you
a better idea of the setup and IP ad...
Thanks for the help guys!!There was nothing in the ARP table which is
obviously an issue. We ended up resetting back to the factory defaults
and it worked. Appears to have been a bad config file. Thanks again!
Sorry, yes the switch is routing and I have .129 as my next hop in
default route on the fortinet. I know I can ping the GW .129 from the
fortinet however I am unable to get to the next subnet GW at
50.206.x.54. Here are some logs and tables I have co...