I have created 2 x vdoms, each vdom has a vlan assigned to a single
physical port (set interface "port#"). If I create a security zone named
"Zone1," the only option is to assign a VLAN from that specific VDOM.
Both physical ports are connected to a ...
Hi all, Do Fortigate Firewalls support "BGP peer groups" by sharing the
same outbound policies and setting instead of configuring each BGP
neighbor individually and updates replicated to all peer group members.
I can't seem to find any docs or comman...
Hi Community, I have imported the configuration for 1 VDOM into Forti
Manager (7.6) and after imported successfully, it's still at "modified"
status. I changed Routing objects and BGP directly on the Firewall, FGM
and FGT immediately went out of sync...
Hi, I am using Multi vdom setup on my Firewall, on the 2nd VDOM I have
noticed when I have created the 2nd virtual interface vlan on the new
VDOM on the same physical internal ports as the 1st vdom, I notice the
physical ports are greyed out on the 2...
I generated a CSR on one of my Fortigate firewalls that contained over
10 SAN's entries, the certificate was signed by my internal company CA,
I then imported the PEM into the Fortigate firewall successfully to use
for HTTPS access, then by mistake I...
how about creating a LAG interface in the root vdom, adding both both
ports physical ports to the LAG interface, then assigning the LAG
interface to the VLAN interface to each VDOM? config system
interfaceedit "LAG-CORE"set vdom "root"set type aggreg...
That is kinda disappointing, I know as @Toshi_Esumi Tosh_Esumi mentioned
every vendor has their own BGP implementation, but Fortinet should look
at what major networking vendors are doing, such as Arista and Cisco,
and follow the same. After all Fort...
There only seems to be a range option; i.e., you cannot stipulate the
neighbor-group association under a peer config. With Cisco and Arista,
however, you can do this. I would need to test to see if the range
covers multiple /32 networks and how many ...
Many thanks for your reply, and the info. I have three VDOMs, and I have
specifically configured PL, RM, and BGP for this particular VDOM only,
which is out of sync. What I am concerned about is whether I
push/install the policy my PL, RM's and BGP w...
