My Setup:I have a IPSec tunnel setup with the right side (Strongswan)
sharing the internet 0.0.0.0/0.0.0.0 and left side (Fortigate) sharing a
specific subnet. What I want to do:dI want to route a specific set of
domains from the subnet over this tun...
This is for Site to Site, not sure how the domain bit works for this.
For my local address in phase 2 its the address of the subnet and for
remote is 0.0.0.0/0.0.0.0 since the other side is sharing the internet
and the local address on that side is 0...
This is what I see, IPs are sanitizedS* 0.0.0.0/0 [2/0] via
XXX.XXX.XXX.XXX, wan1, [1/0]S XXX.XXX.XXX.XXX/32 [10/0] via PHN Tun
tunnel XXX.XXX.XXX.XXX, [1/0]S XXX.XXX.XXX.XXX/32 [10/0] via PHN Tun
tunnel XXX.XXX.XXX.XXX, [1/0]S XXX.XXX.XXX.XXX/32 [10...
