Hi, I have a fex-40d which I would like to use to provide primary
internet access for a remote fortigate 60dI initially configured the
fex-40d to local mode, passthrough. This worked for a few weeks but then
stopped working and I had to do a sim swap...
I am trying to connect to a fortigate 80E running 7.4.7 to roll back a
software version but I am having difficulty connecting to the console
during the boot process. I can connect to the console port via putty
when the Fortigate 80e is booted and up ...
I have two fortigate 90d's both running v6.0.17 build0528 (GA)I have
configured the default web filters identically and applied to the
policies However, on one 90D it will block all the wildcard url's I
enter but the other only does work I also see o...
Hi I would like any request for a specific FQDN to be routed over an
IPsec Tunnel to a remote site and for the traffic to pass over the
remotes Wan interface to the internet. Does anyone have a recipe for
this configuration? I can see that I can crea...
I have a central site (A) with a static IP and many other sites (B, C
and D) that create dialup IPsec tunnels back to site (A) Subnets at site
(A) can reach subnets at sites (B, C and D) and sites (B, C and D) can
reach subnets at site (A) But I have...
Is anyone else having this issue? Is there any other way of restoring an
older fw other than via the gui? 7.4 has stopped me from being able to
move between versions for testing
I very much appreciate the response, but here is what is happening.
First of all the outage, loss of internet access was resolved by
performing a sim swap with the telco, not sure if the telco is blocking
the fortiextender or if the sim was just fail...
To be clear, when I am connected to a fully booted 60e 0r 80e at 9600 I
have no issues. It is only during the boot process that I have the
issue. I read that during the boot process, the Baud rate changes to
115200, which I have tested but it doesn't...
I may try this, I have a 50e that that LAN side is very slow, even with
a blank config on the latest FW. Are you just using a reflow hot air
blower directly on the top of the chip? Whats your method?
