Hello Selim,> How can I find out if Fortinet services are down? Please
refer to the below website to see if the FortiGuard services are down or
not.[link]https://www.fortiguard.com/service-status[/link] Kind
regards,Kavin
Hello,Looking at your model you might be running an old firmware version
on your FortiGate.I would say, just use the FQDN address object if the
firmware version you are on supports FQDN address objects.Regards,Kavin
Patel
Hello,> 2021-06-25 08:22:58.218316 wan1 out Z.Z.Z.Z.54804 ->
X.X.X.X.3432: syn 3033647415Looking at this output, it looks like the
SYN packet was sent out using the correct public IP address.I would
recommend to check the traffic on the other side or...
Hello Benson, > I am finding advice/recommendation of performance SLA
setup for one Link without sdwan ( virtual-wan-link ), thx?Looking at
your requirement. You can use link-monitor feature (CLI only) on the
FortiGate. https://kb.fortinet.com/kb/doc...
Hello, Looking at what you mentioned, it looks like you are already
allowing the traffic to flow through the FortiGate.If the server is on
the Internet, then please check if you have NAT enabled on the policy.
Furthermore, you can use the following c...
