Description
This article describes how to implement 802.1AD QinQ, and how to span the inner (Customer) VLAN across two physical interfaces for connectivity between the LAN and the remote site.
This is the topology used:
Scope
FortiGate.
Solution
S1 is a switch with an SVI on Vlan10 and IP 192.168.10.1/24, this will simulate one client at site 1.
S2 is the same but at site 2.
PS 1 and 2 are the Provider Switches interconnecting both sites.
The configuration shown below will be the same for both FortiGate appliances.
The first step at the FortiGate is to create the 802.1ad Vlan:
config system interface
edit "service-vlan"
set vdom "root"
set vlan-protocol 8021ad
set device-identification enable
set role undefined
set snmp-index 9
set interface "port3"
set vlanid 3221
next
Next, Vlan10 using 'service-vlan' will be created as the 'parent' interface, this will be the inner tag, also referred to as the Customer tag:
edit "vlan10-service"
set vdom "root"
set device-identification enable
set role undefined
set snmp-index 10
set interface "service-vlan"
set vlanid 10
next
Create another VLAN with the same tag, but a different name, this will be the Vlan10 facing your LAN:
edit "vlan10-lan"
set vdom "root"
set device-identification enable
set role undefined
set snmp-index 11
set interface "port2"
set vlanid 10
next
end
Create a software switch that will bind both vlan10 together, this will make traffic between both logical VLAN interfaces possible. For this to be accomplished there should be no references on the configuration for these VLAN objects, that is why the role was set to undefined because some FortiOS versions automatically configure address objects if the role is set to LAN:
config system switch-interface
edit "sw100"
set vdom "root"
set member "vlan10-service" "vlan10-lan"
next
end
If it is wanted to have an IP on this VLAN, it is needed to specify it on the switch interface:
config system interface
edit "sw100"
set vdom "root"
set type switch
set IP <your IP>
set snmp-index 12
next
Configuration is now done, and it should be able to have connectivity between S1 and S2.
Here is a packet capture at FortiGate1 port2 where the traffic is arriving with the usual 802.1q tag:
And a packet capture on port3 where the traffic has the outer 802.1ad tag, and the inner 802.1q tag:
This is what the configuration looks like from the GUI:
Related document:
