Technical Note: How to delete an event filter in Shelf Manager

[shaznita]

Description

This article explains how to delete an event filter that has been configured in Shelf Manager.

Scope

Shelf Manager.

Solution

A specific event_filter entry can be deleted by replacing the entry to 0.

1)  To check if any event filter is configured

#clia getpefconfig event_filter

Pigeon Point Shelf Manager Command Line Interpreter

    Active Event Filters:
        None

2)  To configure an event filter.

#clia setpefconfig event_filter 3 80 1 5 02 86 FF FF FF FF FF FF 0 0 0 0 0 0 0 0 0

3)  To check that an event filter has been added.

# clia getpefconfig event_filter

Pigeon Point Shelf Manager Command Line Interpreter

    Active Event Filters:
    0x03: Software Configurable Filter
        Action Mask: 0x01
        Policy Number: 5, Severity: Information
        Source Address: 0x86, Generator ID2: 0xff (ANY)
        Sensor Type: ANY (0xff), Sensor # 255 (ANY)
        Event Trigger: 0xff (ANY), Event Offset Mask: 0xffff
        0: AND: 0x00, CMP1: 0x00, CMP2: 0x00
        1: AND: 0x00, CMP1: 0x00, CMP2: 0x00
        2: AND: 0x00, CMP1: 0x00, CMP2: 0x00

4)  To delete the event filter which was created earlier.

# clia setpefconfig event_filter 3  00 0 0 00 00 00 00 00 00 00 00 0 0 0 0 0 0 0 0 0

5)  To verify that the event filter has been deleted.

# clia getpefconfig event_filter

Pigeon Point Shelf Manager Command Line Interpreter

    Active Event Filters:
        None