I am trying to use two IPoE lines in one fortigate. The configuration is
as follows.IPoE①: for InternetIPoE②: for maintenance such as Windows
UpdateHow should we configure it?I know how to set up only one
line.Should I use VDOM?It is version 7.4.3. T...
Fortigate is not sending icmp redirects."icmp-send-redirect" is setting
enable.I would like to be able to send ICMP redirects using the case 2
pattern.If the PC is in the same segment as the FW,ICMP redirect
responses are possible.However, if there i...
I would like to connect directly from the SSL-VPN segment to the spokes
segment.This is network layout.[PC]------[FGT60E@HUB]--------[FGT60E@SPOKE1]----[LAN@SPOKE1]
| | | --------[FGT60E@SPOKE2]----[LAN@SPOKE2] ・Connection 1
below will be connected.1...
Hello everyone.I have a question about this vulnerability. SSL-VPN
related settings are default.At this time, I thought that I was not
using SSL-VPN.Of course, all communication from WAN to LAN is denied.
But SSL-VPN is enabled by default.If I don't ...
>who is receiving these IPs from IPoE, the FortiGate, or the end
client?It is the Fortigate. I guess I asked the wrong question.Fortigate
could not create multiple interfaces for IPoE, so I solved it in a
different way.Thanks
Thanks for the answer.I did not understand what you said about VLANs.If
IPoE assigns IP addresses based on physical information, then I should
just set up two virtual MAC addresses, right？
Sorry for the late reply.This is solved. (I made sure his advice was set
up properly.） >In addition to the LAN interface, [FGT60E@HUB] also has a
DMZ interface.The cause was that the DMZ interface's type was 「physical」
interface.Resolve it by changin...
