Hi Guys, We need to create two profiles for Remote VPN access on
Fortigate FULL access:Laptop users have all ports open to LAN (for
RDP/SMB/HTTP(s) traffic to servers) and uses UTM-10.20.1.254 as a
gateway the problem is when i configured VPN profile...
Hi Guys, I'm configuring WAF, IPS and SSL/SSH inspection on our web
servers. We have over 20 servers and some of them hosts websites for
different domains.I've managed to configure SSL inspection using
wildcard certificate but how do i configure it w...
HiOur Fortigate is not logging to syslog after firmware upgrade from
"5.4.4" to "5.6.0, Build 1449" Configuration:IE-SV-For01-TC # config log
syslogd settingIE-SV-For01-TC (setting) # show full-configurationconfig
log syslogd setting set status enabl...
Hi, We are having some issues logging Forwarded Traffic (most important
for us) to remote syslog server (splunk).What we have done so far: Log &
Report -> Log Settings: (image attached) IE-SV-For01-TC (setting) # show
full-configconfig log syslogd se...
akrohn wrote:If I understood correctly, your FULL User use your UTM as
default gateway to Internet ?Yes, it's a gateway/proxy to internet and
also a gateway to a production systems through a separate fiber line.
akrohn wrote:But for what do you need ...
akrohn wrote:Now i see your problem.You have configured, that every
traffic (0.0.0.0/0) goes through the tunnel.Yes, for RDP users we want
to have very strict access - only RDP is allowed for that clientsFull
profile will give users full access to LA...
akrohn wrote:config vpn ipsec phase1-interface edit "Full" use "get" to
see all possible entries. set default-gw 10.20.1.254end RegardsAndreas
Tried this before and it doesn't work. Client still gets 10.20.3.201 as
gateway and DHCP server.Below is a ...
I use IPSEC VPN Route-based configuration: config vpn ipsec
phase1-interface edit "Full" set type dynamic set interface "wan" set
mode aggressive set peertype any set mode-cfg enable set comments "VPN:
Full (Created by VPN wizard)" set wizard-type di...
