About joco_ph

joco_ph · 12-22-2013

may i know how many i can set? it seems i can only set one per wan. im using FG100D with latest firmware.

joco_ph · 12-22-2013

hi, i have two wan interface. wan1 is static while wan2 is pppoe. when normal , both are seen on the routing table. when wan1 goes down and goes back up again, ppp1 is gone in the routing table. i need to disable/enable wan2 interface to have it back...

joco_ph · 12-16-2013

my take on fortigate

joco_ph · 12-12-2013

ecmp does not work on ppoe?

joco_ph · 12-12-2013

hi, im implemented per-ip shaping to my single policy. But when viewing the traffic logs it say N/A. is this normal ? is my shaping in effect? also under firewall object, traffic shaper monitor.... it say' s no Data please advise. TIA

joco_ph · 02-15-2014

sms collection for guest

joco_ph · 12-14-2013

policy routing also doesnot work on PPPOe. Firewall policy too does not work even if you force it to route to a specific WAN.

joco_ph · 12-14-2013

for redundancy , yes. to distribute sessions on both links, No.

joco_ph · 12-13-2013

when using ppoe on WAN2, route monitor says it is ppp1. you can not assign it distance or priority thus loadbalancing via ecmp wont work.

joco_ph · 12-13-2013

column in have the same issue on a standalone FG100D.

User Statistics

User Activity

dead gateway detection

pppoe gets lost in the routing table

features are just for read, most doest work

ecmp does not work on ppoe

fortigate 100D per-ip shaping

RE: Features that you would like to see

RE: ecmp does not work on ppoe

RE: ecmp does not work on ppoe

RE: ecmp does not work on ppoe

RE: Application Sensor Not Working