Hi, I have 2 fortigates a 60E and a 20C I have established the IPSec
tunnels for site-to-site vpn. The tunnel in both fortigates appears to
me to be up, but I cannot ping between the lan networks. I have set the
static route and added the access poli...
Hi, thank you four your time, i disable the NP acceleration for IPSEC
VPN phase 1 and i still can't receive inbound traffic and port 500 is
still used when i do this command.diag sniffer packet any 'host ' 6 0 a
Hi sw2090 thank your for your time. I follow this link to
troubleshooting the IPSec
phases.https://community.fortinet.com/t5/FortiGate/Technical-Tip-Troubleshooting-IPsec-VPNs/ta-p/195955?externalID=FD46611
And if run this command in my Fortigate 60E...
Thank you, i did the flush command in both Fortigates, but the tunnel is
going up after that without i do a ping. And then i ran the sniffer
command in both fortigates, but the packets still use the 500 port and
not the 4500. diag sniffer packet any ...
Thank you! So what I have to do is go to:1. IPSec monitor and bring down
the tunnel or Go to Network-> Interfaces-> WAN-> Tunnel interface->
DisableAnd once the tunnel is disabled, I ping from my lan network
behind the fortigate 60E, right? And alone...
