Hey All,I am having an issue with setting up VIPs to redirect incoming
traffic on a FortiGate with Central NAT enabled to a remote public IP. A
few months back, I had a need to change existing VIPs that mapped from
public to private, so that the new ...
Hi All,We have a Hardware Switch set up on our HA pair of 200F units on
7.0.12. We have Ports 1-8 assigned to the HS, but we only currently use
Port 1. I would like to change the HS to only be assigned to Ports 1-4
so I can reuse 5-6 for a second HS....
@rahulkaushik-22 We previously had VIPs configured for public to
private. However, we are moving the processing of this data off-site.
The data is sent in by thousands of devices out in the world, so
reprogramming all of those would be a monstrous ta...
We got this working! As it turns out, I had to change the interface on
the VIPs from 'wan1' to 'any'. As soon as I made that change, it started
working perfectly. I don't quite understand why that worked, but it did.
Thank you for your reply, Rahul! Ans: Check MAC address of the
destination and make sure it's Fortigate MAC. Sniffer captures traffic
on wire so you will also seen the traffic not belongs to Fortigate.Okay,
understood. you need to select private IP b...
