Technical Tip: How to restart the wireless control...

mibekwe · 05-05-2017

DescriptionThis article describes the steps for packet capture on the FortiSandbox.SolutionFortiSandbox supports the standard “tcpdump” command.> tcpdump -ni port1tcpdump: verbose output suppressed, use -v or -vv for full protocol decode listening on...

mibekwe · 03-31-2017

DescriptionThis article explains how to route specific local subnets to the Internet through a remote VPN gateway.The following network topology will be used in this example.Network topology--- local subnet 10.31.0.0/255.255.252.0 --- wan2(80C device...

mibekwe · 08-31-2016

Description This article describes the process for restarting the wireless controller daemon on the FortiGate. Restarting the wireless controller daemon is usually preferred to rebooting the FortiGate device when troubleshooting wireless connectivity...

mibekwe · 07-29-2016

DescriptionThis article describes the steps for choosing the security mode for the wireless interface via CLI.SolutionCLI:config wireless-controller vapedit set security endwhere: Name for this Virtual Access Point.Available options for securityopen...

mibekwe · 06-30-2016

Description This article describes the steps to disable or enable intra-SSID privacy. Enabling intra-SSID privacy blocks communication between clients of the same access point.This feature is disabled by default. Scope FortiGate. Solution Use the fol...

User Statistics

User Activity

Technical Note: How to use packet sniffer on the FortiSandbox

Technical Note: How to route specific local subnets to the Internet through a remote VPN gateway

Technical Tip: How to restart the wireless controller daemon

Technical Note: How to choose security mode for the wireless interface via CLI

Technical Note: How to configure intra-SSID privacy

Technical Tip: How to restart the wireless control...

KCS