I have created a tunnel from StrongSWAN (AWS) to FortiGate. The tunnel
is up but when I try to ping between the private networks a diag debug
flow filter addr 10.50.255.10 shows "Failed to find IPSec Common". I
have been unable to find any informatio...
Looking at the IPSec VPN Tunnel Network, should local gateway be active
with the Fortigate Public IP address. Image attached. Also, if adding
the local gateway will this stop internet traffic from users going out
the same interface?
Thank you for the quick response! I am new to FortiGate and appreciate
the help.On the IPv4 Policy for forwarding to the internal network there
is no NAT enabled. Are you talking about a different option? Below is
the output fromFortiGate # diag vpn ...
