Hey guys, I'm hoping someone can help me. I have recently replaced
unmagged switches with a Cisco 3650 switch and setup inter-vlan routing.
I have created 4 vlans to segregate the network (vlan10 management,
vlan20 servers, vlan30 end user device, vl...
Hi I am new to Fortigate and i've got a query regarding my setup.Device
100E running v5.4.5,build6225. I've created a WAN LLB for interfaces
WAN1 & WAN2 and setup LLB rules to priortise oubound traffic out certain
interfaces. This works fine and fail...
anurag wrote:As did in FGT 300C & cisco3650, I didn't use any extra
routing. I made ipv4 policies to allow access the users to another
vlans.It is working since 3 years. Can you see any issues with the way I
setup mine? I have 1 ipv4 policy instead o...
ede_pfau wrote:yep, but halfways only...where are the VLANs on the
switch? Why don't you declare the switchport which connects to the FGT
as a VLAN trunk and run all 4 VLANs over it? That's how it was setup
originally but i had reverse path check iss...
Hey guys - I have made the following changes. Disabled asymmetric
routing on FGT Removed ALL VLANS from the FGT. Removed all physical
ports from the LAN interface apart from port1. Configured LAN interface
to 10.0.200.1 (FW IP address) and disabled S...
Hi Anurag, Thank you for your reply. So in your example, i would
associate each VLAN its own interface on the switch and FGT. On the
switch port assign it an access port to the desired VLAN? I would not
need to put in any default routes on the switch...
Yes, I think thats what i want to steer away from as its causing issues
with my routing. At the moment I have a default route on my switch point
traffic to the FW so all traffic is going over VLAN10. At the moment i
have asymmetric routing enabled so...
