Kindly Do the following : Re-Check : IPSEC Tunnels phase2 IP selectors
settings for both site A and Site B . Check the access policies for the
IPSEC VPN Tunnel ,If it requires any NAT configuration for the VPN based
access policies . Please check if ...
To answer the second part of your questionThe conflict is shown on the
Forti manager:Please ensure all device & access policies deployment
changes are performed from the Forti manager only such that it could
prevent to avoid conflicts. Also please an...
To answer the first part of your question: Assumptions for a best
generic access policies design from forti manager please make sure the
below are constant:[ol]Ensure Sub Interface selection. VLAN ID, VLAN
name are finalized, this is a pre-request re...
Hi All ,Please Peform Pre-Check for Fortigate to Forti analyzer
connectivity the below[ol]Firmware Version of FGT and FGA should be
same.Ensure the port are open between the FGT & FGA TCP/514. Check If
there any NAT applied to reach the FortiAnalyzer...