Hi all, Im having a hard time changing the OSPF metric from 10 to 20 on
some of the routes below in my Hubs routing table, i require ECMP for my
SDWAN to work properly on my Hub. My routes of interest are as follows:
O E2 192.168.2.0/24 [110/10] via ...
Hi all, I have quite a complex issue with BGP and how to manipulate a
specific path selection. So i have an ADVPN topology with one hub and
two spokes, the Hub and spokes have two WAN connections each, the
primary WAN connection is using ADVPN so the...
Hi all, This is my first post on these forums, so hello to everybody :)
I'm going to start by asking a question i don't expect many people to be
able to answer but i hope somebody who is familiar with BGP and ADVPN
can crack this one. I have labbed u...
Thanks guys for the replies. I think a diagram may have helped to
understand this scenario better. I got this working but i had to
redesign the whole thing. using the below example i have modified it.
http://cookbook.fortinet.com/client-side-sd-wan-i...
Hi. Thanks for your input, its a good point Eric, i guess if i could
cost them as below, then it would not be equal cost and the routes with
the cost of 20 would disappear, what i want to achieve is a routing
table that looks like this. Current Hub r...
I have managed to progress this slightly by adding a second route out
the VPN interface. I realized that when i shut the VPN interface down
the route dropped out, so i added a higher cost route out the other VPN
interface solves the recursive issue. ...
