Hello, i want to configure my 3 WAN Connections in a way that 2 of them
are Load Balanced by Volume / Sessions and a 3rd one as FailOver only if
all other connections Fail. Is that possible? I tried to set the Weights
to 50 for WAN1, 20 for WAN2 (acc...
Hello, i have 3 WANs configured properly with SD WAN and Load Balancing
with Spillover. I also have some Policy Routes to route specific traffic
via a specific Interface. What i'm unsure about is if it is possible to
create a rule to prevent traffic ...
Hello together, i just migrated from 5.2 to 5.4 and set up the new LLB.
What i'm wondering about is that the new WAN Status Check has a "global"
IP Setting for all WAN Connectionsin the LLB. This IP to ping would then
be my single point of failure......
Any news on this? Same behaviour with me after Upgrading to 6.4.7 - i
use SD WAN with Volume based load balancing and SSL Inspection... Is
this a concern or can i ignore those?
I just tried this configuration - problem is that no second default
Route pointing to 0.0.0.0 is allowed by Fortigate. Message isYou cannot
have duplicated routes on SD-WAN and non SD-WAN interfaces. I searched
the forum but i only found some threads...
