I have a Fortigate 30E that I am trying to get SNAT and DNAT working
over a VPN tunnel to a Cisco 4331.The LAN is a Registered public network
that belongs to the company I work for, I will use 1.1.1.0/24 for this
scenario.I have created a site-to-sit...
Hello everyone, Michael here. I am new to Fortinet. I have a Fortigate
30E and I am trying to setup a unique network that my company already
has in use on Cisco and Cradlepoint. I will be using a Cisco router as a
HUB at our corp office. Each remote ...
The LAN network needs to be hidden always. Multiple remote sites will
use the same IP network for their LAN. The IP pool will change and that
is was identifies that remote site. So the NAT needs to be
bi-directional once the VPN tunnel is established...
Attached is a drawing. The VPN will only be brought up from the
Fortigate, but once the tunnel is up it is necessary to be able to ping
the appliance and nodes on the LAN from the 4321.
Lobstercreed and emnoc, thanks for the replies! I will answer
Lobstercreeds questions first.1. From the 30E LAN 1.1.1.111 which
translates to 10.209.253.111 and I can ping 4331 Loopback address
10.250.110.98. This brings up the VPN and I confirmed wi...
