Dear All, I'll try to keep this as short as possible, my hardware is
1500D running 6.0. With this design I'm trying to: * Share two ISP
connections across multiple VDOMs (named VD_APPA, VD_APPB, VD_APPY,
VD_APPZ) * All VDOMs are layer 3 (NAT mode)* N...
Dear All, I would like to enable BGP graceful restart on my FGCP cluster
like this: neighbor x.x.x.x set capability-graceful-restart enable
[...]next What needs to be configured on the Cisco peer? As far as I can
tell, the upstream peers need to be "...
Dear All I would like to run eBGP across an FGCP pair (A-P mode) with a
transparent vdom. Could you take a look at my diagram and let me if this
looks feasible please? My questions are: 1. Is my addressing with a /29
subnet ok and a single manage-ip ...
Dear All, When running FGCP is there any way to maintain a separate MGT
IP on the active and passive FGTs? I can see that the data-plane
interfaces on the units need layer two reachability because in the event
of a failover the IP and MAC will float ...
Dear All,I would like to migrate to a stacked vdom with the root
learning a BGP default and relaying this to around 10 sub-vdoms via an
inter-vdom link with an iBGP peering across the inter-link. I need to
get around 10-15 Gbits though the platform a...
Also to mention that if you do FGCP HA, the MGT IP will also be shared
between the two units. To manage the slave, you need to go to the master
and do "exec ha manage X". There are some workarounds for this, but they
didn't work well for me.
It's difficult for us to answer without knowing whether the server and
client are separated via the internet or an internal LAN. I'm no expert
in Hikvision, but you may not need to open the full table, depending on
which products/features your enviro...
I'm just updating this thread with some closing remarks in case it helps
others.Basically there are two features which would be interesting to
allow independent management of the units when running FGCP a-p mode.
#1: ha-reserved-management/ha-direct/...
Another important discovery is that FMG doesn't work with the
ha-reserved-management IP. It will add the device correctly, but once
you install a policy the installation gets stuck at 35% and the FGFM
connection will drop. There is a KB mentioning th...
Hi Ken, Incidentally, if I enable it globally on the switch will there
be any adverse impact for peers where Graceful Restart doesn't apply?
What I mean is that the switch has lots of upstream peers which are
single sup routers/switches and not clust...
