Solution: I simply didn't correctly set my public IP correctly in the
Azure portal when defining my local network. I used the IP that I
discovered in the appliance and totally neglected that there was another
NAT router further up in my office buildi...
It turns out that I didn't correctly set the public IP in the Azure
portal for the firewall device. It was a silly mistake on my part, but
it's connected now. No changes on the device configuration. Thanks for
the sugguestions!
emnoc wrote:I highly doubt it but what did you configured in the phase1
settings. The failure is auth but are you using xauth along with PSK or
just a PSK? ( confusion ) Typically if it's a PSK mis-match you get a
PSK error in the debug. What exactly...
