Hi all.I have a problem to proper configure FG and FS. I have iternet
modem | | (vlan100) |switch (cisco) | |(vlan100) |switch (fortiswitch) |
|(vlan100) |fortigate When I use Cisco SG-300 (instead Fortiswitch), and
configure port to untagged vlan 10...
Is the router witch has own ip address x.x.x.33, FG on WAN1 has
x.x.x.34On cisco switch all works ok.I have notice one more error, when
Wan1 FG is connected to port6 on Fortiswitch, all network are terrible
low.So with configuration FS is something b...
it must be in vlan 100. It can be in access port in vlan100, but when I
change Vlan100 in FG to access it also does not working.I have read
somewhere"You must configure the proxy ARP with the config system
proxy-arp CLI command to be able to use the ...
Thanks for replay.gradius85 wrote:When you say "remove switch for cisco"
does that mean you remove the Fortigate switch that is behind the Cisco
switch? Now i have -> modem - cisco(sw) - cisco(sw) - Fortigate. I want
change the cisco switch (connecte...
Hi i have Fortiwifi 60EFirmware 6.0.0I don't have this command. But i
need use each port. xxxxxx (global) # set internal-switch-mode
interfacecommand parse error before 'internal-switch-mode' Command fail.
Return code -61