I'm having an issue with Dual 5g mode on my FP231G APs. Radio 1 is
offRadio 2 is the low 5g channelsRadio 3 is the high 5g channels Dense
deployment (it's a school and every classroom has an AP) The issue is
all clients are only connecting to radio 2...
My solution to this was to adjust the power on radio 3.Although both
radio 2 and 3 were both set to the same level (7dbm), the signal level
to the client was much lower on radio 3. Currently radio 2 is set to
7dbm and radio 3 is set to 12bm. This res...
Thank you for your reply. Does this command increase the radio power to
full?I have a very dense deployment and full power on the AP would not
be a good choice for us. I do want to say that all the radios are
working: I can see them with good power l...
Firmware is FP231G-v7.4-build0680 I will put the APs back into dual 5Ghz
mode and check the output of that command. I do not believe it's POE
related because I can clearly see both radios propagating when I look at
the WIFI signals with my Fluke Airc...
I would recommend 2 things: 1. Turning down the transmit power of your
APs. We have a dense deployment in a high school, there is an AP in
every room and we run the transmit power at 7dbm2. Enable the 'remove
sticky client' option in the advanced sec...
