Hi,I am trying to create "Overlapping subnets for a VPN tunnel" The VPN
is UP, but there is no traffic flowing through Tunnel.I have create
Policies but when I checked the Route table, there was no Static Route
created by the Wizard, I tried recreati...
Hi,Thank you for your reply..Is there a command to print the whole
Tunnel config output? Will share the same here..Yes the other side has
created a NATed cnfig on their side.Thank you
Hi,Thank you for your reply..After executing the command diagnose
sniffer packet any 'host 100.100.100.100' 4 a and pinging the IP...Its
going out Via WAN1...The VPN tunnel is setup with WAN2Thank you
