Fortigate 90d running 5.4.2, happened on 5.4.1 as well.Very often, my
FG90D is at very high CPU utilization.Diag sys top shows reportd is
always the culprit. I've tried a lot of things, and cannot resolve the
issue.Log Settings -> Enable Local Report...
Looking for the best way to support multiple ISPs for HA without
spending the money or complexity of BGP and PI (Provider Independent)
address space. Network Prefix Translation looked like it would have been
a good answer (RFC6296, keeping everything...
Finalizing the post for me.5.4.4 resolved the issue.As I said
previously, there was a spike immediately after upgrading to 5.4.4 that
led me to think it didn't resolve the issue, but CPU Utilization has
been as expected in the two weeks since that pa...
I had the problem immediately after updating to 5.4.4. Within an hour,
CPU spiked for two hours, again for reportd.However, it hasn't occurred
since then.There are still occasional CPU spikes, but they don't last
for hours (they last for less than my...
Note: There was an entry in the release notes for 5.4.4In the "Resolved
Issues" section, Bug ID 369778 says: FWF_90D daemon report takes 99% of
CPU Time. I'm not running a FWF, it is a FGT90DPOE, and the issue wasn't
resolved. I couldn't find any oth...
I opened a case on this problem.I have a very basic config, and I'm able
to make changes as requested by support.They asked me to update to 5.4.4
build 1117, which is now running, and the problem occurred within an
hour. I will update if the problem ...
