i would like to know if there is way to get to the passive unit in the
cluster and run some commands like "#get hardware nic port1" i need to
know the physical MAC address of each port.
i have similar problem as well. my fortiguard connection was not
working, it was not verifying URL categories...so i went to config >
fortiguard > web filtering and Email filtering options > i chose Use
Alternate Port (8888) and it started working..
i have that same setup (2 600c in A-P mode) here and i've restored my
config a lot of times now... ive done it in two ways: first was to take
the primary unit off the cluster reset it to factory default, restore
the configuration then rejoin the unit...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites