Hi AllI'm trying to prioritise WebRTC traffic on my FG 200b, 5.2. I
enabled DSCP using: config system global set traffic-priority dscpand
set 46 value to high:edit 46 # EF set ds 46 set priority high Would this
be enough for the firewall to prioritis...
Hi GuysI have set up 3CX behind my 200B but can't get calls to work with
NAT enabled. I have disabled SIP helper etc. by following the below:
"config system settings set sip-helper disable set sip-nat-trace disable
config system session-helper show /...
thanks but no joy I'm afraid, this is my LAN > WAN policy:set srcintf
"port14"set dstintf "port13" set srcaddr "3cx" set dstaddr "all" set
action accept set schedule "always" set service "ALL" set nat enable set
fixedport enable WAN > LANset srcintf ...
Just to add I have VIP on the WAN > LAN policy which according to my
research is suppossed to take care of one to one NAT both ways, right?
Anyway it doesn't make a difference if I configure LAN > WAN with IP
pool...No one uses 3CX here?
