Description
This article describes how to generate data sampling report in FortiAnalyzer .
Applicable to FortiManager with FortiAnalyzer feature enable.
Scope
For version 6.4.3 and above.
Solution
1) Create Report:
This article describes how to generate data sampling report in FortiAnalyzer .
Applicable to FortiManager with FortiAnalyzer feature enable.
Scope
For version 6.4.3 and above.
Solution
1) Create Report:
2) Add Chart library .
Predefine chart library: Interface Timeline by Data Sampling.
Predefine chart library: Interface Timeline by Data Sampling.
3) Login to FortiAnalyzer from CLI and configure following.
From FortiAnalyzer CLI:
# config system log interface-statsIt is possible to use following command to check more available option under FortiAnalyzer interface-stats.
set billing-report enable
set status enable
end
# get sys log interface-statsNote.
Before running this report, billing must be enabled for 24 hours or longer.
4) Run report then report will show similar data.
4) Run report then report will show similar data.
Related document.