I have the 60c all setup and everything almost works as I want it to.
1st issue - I created a rule to be able to access LAN2 from LAN 1, both
being on different subnets with the LAN ports operating in -- mode. I
use LAN 1 for all traffic except my Vo...
When I spoke to the Fortinet tech' s, they told me the rule would not
work without this policy and that this was the correct way to do it.
Now, I' m confused...
I ended up installing a policy route that looks like this and it now
works perfectly - it would not work without a policy route - If incoming
traffic matches: Protocol 0 Incoming interface: Internal1 (Non-VoIP LAN)
Source address / mask: 192.168.103....
I started the debug in the CLI - but it gives me a parse error before "
src" when trying to enter " diag deb flow filter src 192.168.103.170" .
I don' t have any experience with the CLI - so it may be me, but I
followed your instructions to the lette...
