I am looking to install a second firewall at a an existing site, they
are currently connected via metro-e that goes from a centurylink rad to
a cisco 9300 which also handles vlan, dhcp, etc which currently connects
us site to site. I have a diagram a...
I am in the process of rebuilding my network, I currently use cisco
9300's to carry traffic to each site via metro-e. The cisco's currenlty
have Vlans and DHCP configured. I would like to implement at each site a
fortigate 200f and 2 cisco 9200's to ...
I am currenlty migrating from checkpoint 3200 ha with smart console to
dual 200f fortigates, my questions, when applying the ip's to the
interfaces on the forti, checkpoint gw 1mgmt: 192.168.x.253/24port 1:
10.76.x.148/24port 2: 4.36.x.70/29 (wan)por...
I just created my vm and I set the static port to port1, when I make
these changes and save the static ip, i lose connection, I've done the
following from the cli: config syst int > edit port1 > set mode static >
set ip 10.76.2.21 255.255.255.0 > set...
I am trying to configure our core Cisco 9300 to pass vlan traffic to
Standalone Fortiswitch FS-224E. I have a ticket opened with both Cisco
and Fortinet and have had both engineers on the phone but we were not
able to get it to work. Does anyone have...
I agree, not a fan of checkpoint and we are looking to move away from
it, have these three 200f firewalls that we want to implement but we are
unable to do it all at one time so we want to start with a remote site
and work our way in.
Yes, metro-e is connected at hq, and it goes to each site using a
century link rad where the fiber terminates and from the rad it goes
into the cisco switch on-site.
config-version=S224EN-7.02-FW-build444-230317 yea each time i reboot, i
have a second 224 swtich and it also does the same thing when you reboot
after configuring.
Update: The settings are saving the issue is with the internal port, it
is set to thisconfig switch interfaceedit internalset native-vlan 100
Somehow it is losing that config, when I console back in and add that to
port 1 I gain access to gui and pin...
Ok, so new issue, when I put the switch in the building where it's going
to go, what's going on now is that when I power cycle the switch I lose
access to it I can only connect using cli. Any idea?