Morning. Hopefully this will make sense. We have 201F's running in HA
(internet side). We have 101F's running in HA on our lan side. We use
FortiAnalzyer. The 201F is the root fabric, the 101F was originally in
standalone mode.I thought I would join ...
Good morning. We have a site that is very tiny and pretty straight
forward. One FW 81E and two FS 248 E_FPOE.A third switch in the mix is
an older Cisco 2960. Everything was working fine for years (and yes new
equipment for the site have been ordered...
Morning guru's.I have a small customer with a Zxyel USG-200. We are
replacing with Fortigate 101F.Transparency: I am not a FW guy - dabble I
can do! Anyone moved or copied configs from a Zyxel device to Fortigate
successfully? Looking for advice, bes...
Afternoon.What is best way to allow IP address - using SSLVPN from a
BLOCKED Country.Thank You PS: some TAC sites are located in blocked
countries; creating IP address list to allow access but not cooperating
Afternoon.Quick question - hopefully it's not too bone headish of a
question. I'm still learning and something was plopped on my lap.I need
a Subnet 192.168.247.0/24 (VLAN 247) to talk to our main LAN
192.168.0.0/23Any advice appreciated. We have dev...
Hi Sheikh and thank you for responding. We will look at some of your
suggestions, however this was operational (for many years) up until we
swapped out the FS 248E (same model) and updated the Fortigate firmware.
I was wondering what may have changed...
Hey Toshi. Thanks for the reply. We are working on getting hands on this
old unit. Last update I got from an employee on site was no link
activity on the port - no LED period.
Hi AEK. Went straight from 6.0.4 to 7.0.13 on the FW. The replacement
248E already had 7.0.12 - the old one was 6.0.2. The cabling between
buildings is on MMF, plugged into the FS. I can get you FS configs -
working on the Cisco configs now. Cisco is...
We have 101F's and 201F's in HA with a lot of 448EFPOE. 1024D's is our
distribution switches. We segmented the heck out of our network and
created a load of vlan network interfaces. We isolated the mgmt vlan
4094. Same as what AEK said above.
