Hello, We have a FortiGate 200E as one of our devices.After a factory
reset by using the hole pin method, we are unable to access the device
anymore.The status flashed for a while, the ports flashed, then the port
lights were stable, then status was ...
Hello, We have a few Fortinet devices and are trying to configure the
network with only partial success so far.This is an early design doc
that I can share with you, the main difference is we have opted to using
just 1 switch on each level for now. ~...
Thank you @adimailig, I was able to factory reset the device through the
console.I am now able to use the device properly from the web GUI.
Regards, VM
Thank you, @adimailig You are correct, it did not factory reset the
device. I am having difficulty accessing it through the console.Need to
purchase a new USB console cable.Would any work or does it have to be
FortiNet specific? Once I get it I can p...
