Technical Tip: Working of 'source-ip' and 'source-...

jsarah · 01-30-2025

Description This article describes how the 'source' and 'source interface', in 'ping-options' work in the packet level in the FortiGate. Scope FortiGate v6,v7. Solution The following options are present in the FortiGate for ping: iron-kvm03 # exec pi...

jsarah · 10-30-2024

Description This article describes the command 'diagnose netlink device list' which helps to display all the interface counters of the FortiGate device at once in real-time. Scope To check if any rapid increase in any drop counter or to check/verify ...

jsarah · 09-23-2024

Description This article describes how to perform debugging to see if a link monitor is occurring in FortiGate. Scope FortiGate. Description In troubleshooting scenario to see if FortiGate is performing link monitor and its status. Perform the follow...

jsarah · 02-12-2024

Description This article describes how to check which profile of the file filter the files matching Scope FortiGate v7. Solution Run the following command: diagnose sys scanunit debug file-filter enable diag debug enable<----- To start debug, // init...

jsarah · 08-01-2023

Description This article describes how to configure the PPPoE interface in FortiGate if ISP does not have an IP but just a VLAN ID. Scope Firmware 7.0 and above and in CLI only. Solution Step 1: Create a VLAN interface/sub-interface under the require...

jsarah · 08-27-2024

Hi Team, No. But it will depend on packet flow. If your vlan interface is ingress interface for packet then no need for policy. Otherwise policy will be required.

jsarah · 11-17-2023

seems like a new feature is added. If time difference between ntp obtained time and manually set time is more than 2 mins, then this error message will appear https://community.fortinet.com/t5/FortiGate/Technical-Tip-FortiGate-time-is-out-of-sync/ta-...

jsarah · 08-01-2023

Hi, You can check the web rating here : https://www.fortiguard.com/webfilter

jsarah · 08-01-2023

could you please share the block message seen in browser , when you are trying to load the website.

jsarah · 07-26-2023

may I know, why you want add application control to the policy. You can simply add service ssh to that policy.

User Statistics

User Activity