Description This article describes how to use an automation stitch to
run a CLI script and bounce the FortiGate interface during a fixed
interval of time. An explanation is provided for how to bring down the
interface and up during a scheduled time. ...
Description This article describes how to resolve a scenario where the
wireless clients are not able to authenticate to the wireless SSID while
using the RADIUS-based security. Scope All FortiGate. Solution On the
FortiGate, the EAPOL client start me...
Description This article describes the CLI configuration steps to
configure FortiExtender to operate as a WAN extension with a FortiGate.
This article is most useful when the FortiGate GUI is inaccessible.
Scope All supported versions of FortiGate. S...
Description This article describes the case when an HA cluster cannot
join the security fabric. When trying to authorize the device on root
fabric, the serial number is not present. When trying to pre-authorize
the device via the CLI, the following e...
Description This article describes the situation when the FortiGate was
replaced after restoring the configuration and the IPsec site-to-site
tunnel was still not up. Scope FortiGate. When the devices are replaced,
and configuration is restored after...
Hello k-saku,Please provide the following command output diag debug
reset diag debug application sslvpn -1 diag debug enable Please check if
TLS 1.1 and TLS 1.2 are enabled on the FortiGate, enable them in
Internet Explorer as well.Thanks
Hi van_sta, Please refer the following document for 2 gb models,
https://community.fortinet.com/t5/FortiGate/Technical-Tip-FortiGate-is-entering-into-Conserve-Mode-during/ta-p/287053
Let us know if it helps Thanks
Hello, which FortiClient version are you using Are you using windows 10
enterprise? Make sure the windows defender is disabled Could you please
attach the screenshot with the error Thanks