Description This article describes how to modify route preference using
Local-Preference Attribute in BGP. Scope FortiOS. Solution Local Peer:
10.9.26.94 configurations: On this FortiGate, there are two BGP peers:
10.9.17.42 and 10.9.26.163. get rout...
Description This article explains why FortiGate replies 'Telnet to local
telnet server is not allowed' when trying Telnet to an IP. Scope
FortiGate. Solution Example Output: FGT-61E # exe telnet 192.168.100.1
443 Telnet to local telnet server is not ...
Description This article describes how to obtain the WAN IP from the
FortiGate CLI. Scope All versions of FortiOS. Solution Run the following
command in the CLI: diagnose system wan ip This will grab the public IP
of the default connection from https...
Description This article describes the configuration requirements on
FortiGate to connect the FortiSwitch to FortiGate's physical interface
and manage it. Scope FortiGate. Solution Create a new LAG-interface and
add physical interface(s) as its membe...
Description This article describes how to modify the SSL-VPN replacement
page to redirect to other website. Scope FortiGate. Solution Note: Here
the SSL-VPN Login Page is redirected to www.google.com Do this only to
completely block the SSL VPN login...
Hello Furil, Good day!Port 3 and port 4 (session sync dedicated) must
they be in the same vlan ? I don't think they should be in same vlan. I
referred this article:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-HA-session-sync-dev-configu...
Hello xxx22, Good day! Is this a new deployment or an existing one? Are
you aware of any trigger point that caused this behavior? Please make
sure that Phase2's "Key Lifetime" is same on both the peers.
https://community.fortinet.com/t5/FortiGate/Tro...
HelloI would suggest you to please factory reset the switch (exe
factoryreset) and follow the link to add the switch
again:https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-add-connect-FortiSwitch-to-FortiGate-on-any/ta-p/270600Thank
y...
Hello fran19422, This is because of the CG-NAT used by Starlink. You can
refer below forum for more details.
https://community.fortinet.com/t5/Support-Forum/IPSEC-tunnels-behind-CGNAT-Starlink/td-p/226976Thank
you!
Hello matthewv, Good day! I think you should check the data sheet for
400F. here is the link
:https://www.google.com/url?sa=t&source=web&rct=j&opi=89978449&url=https://www.fortinet.com/content/dam/fortinet/assets/data-sheets/fortigate-400f-series.pdf...