Description This article provides the FortiADC Server Load Balance
Layer-7 UDP Virtual configuration to enable NAT Source Pool using Stream
Scripting. Scope FortiADC. Solution Configurations: Layer-7 TCP or UDP
Virtual Server does not have the option...
Description This article describes how to fix the uWSGI crashes issue
due to old greenlet package version installed and integrated. Scope
FortiSOAR v7.6.1. Solution Behavior: FortiSOAR partition '/var/log' disk
space consumption increases abnormally....
Description This article describes the steps to configure the default
HTTP content routing server to route non-matching HTTP content routing
host or URL to a default landing page server. Scope FortiWeb. Solution
Prerequisite: The server policy uses a...
Description This article describes how to debug the URL Rewriting module
using CLI debug commands in v7.4.x or later Scope FortiWeb v7.4 or
later. Solution Prerequisite: Server Policy Web Protection Profile has
the URL Rewriting module enabled. The F...
Description This article describes how to configure custom values for
the FortiWeb SNMPv3 Engine-ID. Scope FortiWeb. Solution Prerequisite:
FortiWeb SNMP Agent is enabled and SNMPv3 is used. Able to use hexdump
command to convert the Engine-ID string...
Hi Zdenek, The cost of enabling the FortiView is minimal, but it does
consume CPU/memory resources and will be consuming more if there are
hundreds of virtual servers noticeably on the memory consumption. That
is why the FortiView is disabled by defa...
Hi Dairu, Sorry for pasted the duplicate link. Here's the link for IIS.
https://techcommunity.microsoft.com/t5/iis-support-blog/how-to-use-x-forwarded-for-header-to-log-actual-client-ip/ba-p/873115
HTTPS packet should have been encrypted where you mi...
Hello Dairu, Hope you are doing fine. In regards to the
"X-Forwarded-For" header, if you are able to capture the header in the
pcap, then it would be a correct setup in FortiWeb. While the next thing
will be the webserver to capture the "X-Forwarded-...
