Description This article describes step-by-step instructions on how to
implement a guest network solution based on FortiOS using a bridge mode
SSID with HPE Aruba ClearPass version 6.11.6 as a captive portal. Scope
FortiGate 7.0 and above. Solution C...
Description This article describes step-by-step instructions to
implement a guest network solution based on FortiOS using a tunnel mode
SSID with HPE Aruba ClearPass version 6.11.6 as a captive portal. Scope
FortiGate 7.0 and above. Solution Configur...
Description This article describes how to enable the FortiAnalyzer Cloud
option for logging on the FortiGate. Even though FortiAnalyzer Cloud
entitlement is included in the license, the FortiAnalyzer Cloud option
is grayed out in the Logging Settings...
Description For some of the instances, the source IP address or
interface can be mentioned for local out traffic. This article describes
a case where it will not be possible to mention the interface in
configuration through CLI. Scope FortiGate. Solu...
Description By default, when a new IPv6 SLA is configured, it will only
allow PING as a protocol, as shown in the following image: Scope
FortiGate 7.0 and above. Solution After configuring IPv6 SLA with Ping
Protocol, other Protocol options will only...
Hello, this might help you. someone have mentioned the steps to follow
if you can have a look at them :
https://answers.microsoft.com/en-us/windows/forum/all/could-not-open-key-verify-i-have-sufficient-access/febca544-a21b-4302-bc15-81f7887df807
Than...
Hello, it would be a good idea to run those commands on CLI when IOT
device can reach the internet and when it can not to troubleshoot the
issue.
https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-First-steps-to-troubleshoot-connectivity...
Hello, If an interface has static IP configuration then you need to
provide the gateway member while adding that interface to SD-WAN zone.
In case of DHCP IP configuration, DHCP server provides the gateway
information so you can put 0.0.0.0 while add...