Re: How can I set the forticlient to update itself...

eowusu · 01-11-2024

Description This article describes how to fix an issue where, when one of the devices in an HA cluster has additional VDOMs other than the standard 10 VDOMs per firewall, the HA cluster does not form. Scope FortiGate-3000 or higher (FortiGate-1240B s...

eowusu · 10-18-2023

Description This article describes that the user's outgoing traffic stops passing and is mostly unable to browse the internet when a traffic shaper is configured with limited bandwidth allocated. Scope FortiGate. Solution Run debug flow trace on the ...

eowusu · 12-26-2022

Description This article describes how to encrypt logs before sending them to a Syslog server. Scope FortiGate. Solution Use following CLI commands: config log syslogd setting set status enable set mode reliable end It is necessary to Import the CA c...

eowusu · 06-21-2022

Description This article discusses when FortiGate Session Life Support Protocol (FGSP) is enabled on FortiGate to sync sessions/IPsec tunnels up with another FortiGate, the FortiGate does not support being the initiator. It can only respond to IPsec ...

eowusu · 01-10-2024

You are welcome.

eowusu · 01-10-2024

Yes you will have to upgrade it manually. You can find a list of the latest versions on support.fortinet.com----> Firmware download---> forticlient

eowusu · 01-10-2024

yes that is wrong. Kindly create the static route with the sdwan zone. Once you select interface under static routes. You should see an option for the zone you placed both WAN links in(virtual-wan-link)

eowusu · 01-10-2024

Hello @peacemaker Are you using the free version of forticlient or the EMS licensed version of forticlient? If you are using the free version of forticlient then that option is not available.

eowusu · 01-10-2024

Did you create the default route for each WAN link separately or are they both in the same zone(virtual-wan-link) as a default route? Kindly check that

User Statistics

User Activity

Troubleshooting Tip: HA cluster not establishing when one firewall has more vdoms than the other

Troubleshooting Tip: Traffic shaper dropping traffic due to exceeded shaper limit

Technical Tip: How to send encrypted logs to Syslog server

Technical Tip: IPSEC VPN Tunnel down with FGSP enabled

Re: Remote access and port forwarding to WAN when SD-WAN rules are active