Description The article describes how to change the VPN profile name
without clearing the reference. Scope Fortios 7.4.2. Solution Starting
from 7.4.2, there is a new feature implemented to change the VPN tunnel
name without clearing/deleting the ref...
Description This article describes how to enable and configure ICAP.
Scope FortiGate. Solution By default the ICA option is disabled in the
firewall, it has to be enabled from the feature visibility. Navigate to
System -> Feature Visibility: If it is...
Description This article describes the case when it is impossible to log
into the FortiGate via SSH, or GUI with the Local firewall user. The
user belongs to a remote server (Radius, Tacacs) and can access it.
Scope FortiGate. Solution When it comes ...
Description This article describes that by default, FortiGate does not
log the SLA health check and how to configure the SLA logging. Scope
FortiGate. Solution Here is the config example: set sla-fail-log-period
set sla-pass-log-period Enter an in...
Description This article describes how to use source IP for the local
out traffic in a static route. Scope 7.4.0 and above. Solution This is a
new feature introduced in the FortiOS version of 7.4.0. It is possible
to add the preferred source IP in th...
Hi Kalliem, The behavior of a FortiGate device when a license expires
can vary depending on the specific type of license and the
configuration. In general, here's what you can expect: Grace Period:
Some FortiGate licenses come with a grace period. Du...
Hi Abdal, You may use the option Keep Alive in the phase2 configuration.
The option is to keep the tunnel active when no data is being processed.
Please refer the below
link:https://community.fortinet.com/t5/FortiGate/Technical-Tip-Using-the-IPSec-au...
Hi Mehul, Please note that the ISDB object will not support split
tunneling. It is necessary to manually build an address group and
include all of the Teams addresses. Regards,Babitha M
Hi Chris, Yes, that's correct. If an IP pool is defined but not used, it
can still cause issues with DHCP if the IP pool's range overlaps with
the DHCP range. This situation can lead to conflicts and unpredictable
behavior in the network. When a DHCP...
Hi fabs, Only the user who created with Administrative profile as super
admin will be do changes on the configuration part.User with read only
access will not be able to change anything on the user profile. Also,
need a confirmation that you are look...