Description This article describes the case when system events show the
log message 'User daemon_admin added IPv4 firewall local in policy 1
from cmdbsvr'. Scope FortiGate 7.2.x. Solution When FortiGate has a
firewall local-in-policy, after the Forti...
Description This article describes the case when the address group
configured does not appear in the static route configuration; however,
the address object is available. Scope 6.0.x Onwards. Solution In
certain cases address group configured does no...
Hi LukeLuke1979,You can configure two different IP address on two
different interfaces of fortigate. To remove physical interface from
Hardware/Software switch, kindly check below link and then you can
configure separate IP address on those interface...
Hi Mohamedhh96,Hope you are doing good.On Fortigate we can't customize
the default Fortigate configuration. Please check below link for more
details:https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-reset-a-FortiGate-with-the-default-f...
Dear rojer,Hope you are doing good. Please let us know if you are using
full tunnel sllvpn or split tunnel fortigate ? Kindly check below link
for the full tunnel and split tunnel behavior.
https://docs.fortinet.com/document/fortigate/6.2.15/cookbook...
Hi testerics,For this process crash for httpsd, found in crashlog are
unfortunately incomplete. I would suggest you to kindly open a TAC
ticket along with the output of below , so that we can look into it and
try to match this issue with any known is...
Dear JP57,Please check if the traffic is hitting to the correct policy
and route is present on firewall to point the interesting traffic to
flow across correct IPsec tunnel.Regards,Parteek