Description This article describes what happens when a user's password
is changed or expires while connecting to FortiSASE VPN, and why the
session remains active until the user disconnects or reauthenticates.
Scope FortiSASE. Solution It is expected...
Description This article describes an issue where, when deploying
FortiSASE, organizations are required to select between 2 to 4 Security
Points of Presence (PoPs) to host the security services. These PoPs help
optimize latency and improve service re...
Description This article describes how to set up and maintain an IKEv2
Site-to-Site IPsec VPN between a FortiGate and StrongSwan on Ubuntu
Linux. Scope FortiGate. Solution Once the configuration is complete, the
VPN tunnel may not establish as expect...
Description This article describes how to configure an IKEv1
site-to-site VPN tunnel between a FortiGate and a StrongSwan VPN gateway
on a Linux system. Scope FortiGate. Solution On Linux Install
StrongSwan: sudo apt-get updatesudo apt-get install st...
Description This article describes an issue observed on FortiGate, where
the ipv4-split-include setting in an IPsec Phase1-interface
configuration disappears after modifying the associated address group.
Although the configuration appears intact via ...
You need to setup a cross connection between FGT and FSW There are
multiple topology diagram you can refer once
https://docs.fortinet.com/document/fortiswitch/7.6.1/fortilink-guide/617516/determining-the-network-topology
Hi, yes it can be done using sdwan and if sdwan is not setup and policy
route can be used Refer:-
https://docs.fortinet.com/document/fortigate/7.6.2/administration-guide/413288/sd-wan-rules-overview
https://community.fortinet.com/t5/FortiGate/Technic...
Hi, In fortinet if you want to communicate among the different interface
then you need to setup firewall policy. Please create firewall policy
from port3 to port1 and port2 and vice versa and allowed the required
subnet. Refer:-
https://docs.fortinet...
Hi, Take packet capture on ether frames. diagnose sniffer packet any
'ether proto 0x8890' 6 0 l Refer:-
https://community.fortinet.com/t5/FortiGate/Technical-Tip-FortiGate-HA-Heartbeat-packet-Ethertypes/ta-p/197807
Hi , Its better to reach out to fortinet NSE training team and raise a
ticket with them so that you can get better clarity.
https://helpdesk.training.fortinet.com/support/solutions/articles/73000571109-recertification
Sign in and can raise the ticket
