Description This article describes how to allow IPsec VPN port 4500,500
and ESP protocol access to specific IP addresses only. Scope FortiGate.
Solution For Instance: IPsec VPN site to site with the remote peer of
10.10.10.1 which opened IKE port 500...
Description This article describes steps to troubleshoot VRRP split
brain, where both master node and slave node shows as 'Master'. Given
the VRRP configuration on both sides of the FortiGates are legitimate.
Scope FortiGate, all firmware Solution In...
Description This article describes about the issue where user is unable
to add a hardware switch which is in use into a zone. Scope FortiGate,
all firmware. Solution Adding hardware switch interface, or any
interface as follows in a newly created zon...
Description This article describes about the issue where users are
unable to ping public servers (for testing) using ping-option source
from LAN interface. Scope FortiGate, all Firmware. Solution Consider the
following network, where the LAN facing i...
Description This article describes about security fabric connection
failing over IPSec tunnel. Scope FortiGate, all firmware. Solution
Follow the below troubleshooting steps: 1) Make sure tunnel is up and
running with traffic on both sides of the tun...
Hello, Please update the output of the following: di de rating show
system fortiguard Recommended system fortiguard setting: config system
fortiguard set fortiguard-anycast disable set protocol udp set port 8888
set sdns-server-ip 208.91.112.220 end ...
Hello, According to documentation should be
possible,https://kb.fortinet.com/kb/documentLink.do?externalID=FD40645
"Technical Note: Using Syslog Filters on FortiGate to send only specific
logs to Syslog Server" Navigate to Log&Report>Log Settings> Ev...
Hello Rob, Please check the following document for more information on
API calls:
https://docs.fortinet.com/document/fortigate/7.4.3/administration-guide/940602/using-apisFor
a complete list of API calls, see the Fortinet Development Network
(FNDN). ...
Hello, Starting in FortiSwitchOS 6.4.0, you can run FortiLink mode over
a point-to-point layer-2 network. You can form an inter-switch link
(ISL) between two FortiSwitch units over a layer-2 device or
non-FortiSwitch device (such as a wireless bridge...
Hello Hafer, It is better to contact the seller and have them unregister
from their account. As in case if you have to license your used
FortiWifi 50E in future fo using Security Profiles (UTMs) you need to
register this device with your account. Any...