Description This article describes the functionality and configuration
of DoS policy offload on FortiGate 100/101F and 200/201F models. Scope
FortiGate 100/101F and 200/201F models. Solution FortiGate 100F and 200F
models use NP6Xlite ASIC processors...
Description This article describes how to obtain a certificate using
SCEP enrollment with a specific source IP on a FortiGate device. Scope
FortiGate. Solution In some cases, when an SCEP server is accessed over
IPsec or when an ACL is configured on ...
Description This article describes how to redistribute BGP routes into
OSPF on FortiGates. Scope FortiGate. Solution To enable BGP route
redistribution into OSPF, use the following commands: config router ospf
config redistribute bgp set status enabl...
On the FortiGate, adding multiple certificates in the Virtual Server
config is impossible.A possible solution is to use a wildcard
certificate for both servers that will cover both subdomains like
*domain.com
Please disable add-route on the ipsec phase-1 interface on all involved
parts.config vpn ipsec phase1-interface edit set add-route
disable next endAlso, make sure the IP addresses and subnet is correctly
configured on tunnel interfaces.On HUB the re...
Hello Benny, For FortiClient connections, you can use the peer ID. This
feature is available on both FGT and FortiClient EMS, and it will allow
FortiClient to connect to the correct dial-up tunnel.
https://community.fortinet.com/t5/FortiGate/Technica...
Hi, I would suggest to try 7.2.1 FCT and make sure you provide full-disk
access:
https://docs.fortinet.com/document/forticlient/7.2.1/macos-release-notes/223986/special-noticesThere
are some BUGs on 7.0.9 Free FCT that may cause this issue:
https://d...