Technical Tip: SD-WAN route select for fib-best-ma...

ydong01 · 11-09-2023

Description This article describes that normal API admin could not show super admin user and needs to change profile via CLI: Create Admin Profile for REST API Admin with read-write Permissions 'api-rw': Create REST API Admin 'api-adm' with newly cre...

ydong01 · 11-22-2022

Description This article describes that if 'set default' and 'set gateway' are disabled in the SD-WAN service, it will do a FIB lookup based on the destination IP address. If there is a FIB match, and the FIB interface is an SD-WAN member, it will no...

ydong01 · 11-18-2022

Description This article describes how, when configuring a syslogd filter or FortiAnalyzer filter (in 6.x,), it is possible to define both logid list and log level. However, the logic is not described between the log ID and log level. Scope FortiGate...

ydong01 · 03-30-2020

DescriptionThis article describes local_diag code 0x03 and 0x23 in bfd log.BFD session state UP -> Down local_diag = 0x03.BFD session state UP -> Down local_diag = 0x23.SolutionWhen dynamic routing flap, such as OSPF or BGP state UP -> Down, check th...

ydong01 · 11-29-2019

DescriptionThis article describes automation using Webhook to send messages to AWS Lambda and triggering REST API access for FortiGate blocking invalid access:- Configure basic Block Policy and group on FortiGate- Create AWS Lambda function- Modify f...

User Statistics

User Activity

Technical Tip: How to show super admin user via REST API Admin

Technical Tip: SD-WAN route select for fib-best-match

Technical Tip: In log filter settings, the logic is AND between logid and log level

Technical Tip: Bi-directional forwarding detection diag code 0x03 0x23

Technical Tip: Integrate Webhook and AWS Lambda to block invalid access

Technical Tip: SD-WAN route select for fib-best-ma...

Technical Tip: Use REST API Access FortiGate

Technical Tip: FortiGate Automation use Webhook se...

KCS