Description This article describes the case when WiFi clients cannot
connect to the SSIDs after a FortiAP firmware upgrade via FortiGate due
to fsm-state 'RUN + Image Downloading'. Scope FGT-100F v7.0.11, FAP-431F
v7.2 build0318. Solution SSH into Fo...
Description This article describes the case when FAP-U431F radios show
'PowerDown' status in 'show interfaces Dot11Radio' output on FortiWLC
due to 802.3af PoE power. Scope FortiWLC, FAP-U43xF - v8.5.x and v8.6.x.
Solution FAP-U431F radios 'Operation...
Description This article describes how to collect 'tcpdump' packet
captures. Scope FortiExtender 511F v7.2.3. Solution 1) Access the
FortiExtender with SSH using Putty SSH. Log the Putty SSH. 2) Enable
'tcpdump' captures on any of the following inter...
Description This article describes how to collect 'tcpdump' packet
capture. Scope FortiAP v7.x and FortiAP-U v5.4.3 and higher version.
Solution 1) Take SSH access to the FortiAP via FortiGate CLI or via
Putty SSH and log the Putty SSH: # execute ssh...
Description This article describes the user impact when a Managed
FortiSwitch VLAN interface shows the same MAC address on two independent
FortiGate HA pairs. Scope FortiGate-100F v7.0.6 build0366; MCLAG-ICL
FSW-424E v7.2.1 build0406; Both FortiGate ...
@lenenkash If your requirement is to provide a secondary WAN uplink
connection (LTE) to the FGT then you may try deploying FEX in the "WAN
Extension" mode and then add FEX Virtual WAN Interface to SD-WAN members
for WAN link
failover.https://communit...
Hi @troxad If FGT already has another network in 192.168.200.x range and
if you're trying to bring up another Network (FEX network) then yes it
may create IP Network duplication situation. You can download FGT config
backup and then try changing the ...
@suportewispot 1. I'm assuming that you've already added the following
FortiLAN Cloud servers in the allowed list as clients to access the
RADIUS server: Global server - 173.243.132.78 EU server - 154.52.10.243
JP server - 173.243.132.207
https://doc...
@suportewispot 1. With a FortiAP advanced management license, you can
enable the following advanced settings:
https://docs.fortinet.com/document/fortilan-cloud/22.3.0/fortilan-cloud-user-guide/744374/advanced-settings
2. As authentication is working ...
@suportewispot If the Captive Portal page is hosted on an External
Authentication Server (RADIUS) then you could try using RADIUS
Accounting to control user's session:
https://docs.fortinet.com/document/fortilan-cloud/22.3.0/fortilan-cloud-user-guide...
