Description This article describes how to resolve an issue experienced
when FortiGate shows config-error-log after upgrading from v7.0. tov
7.2. For example : The upgrade from v7.0.12 to v7.2.6 has been
completed, the config-error-log checked and the...
Description This article discusses the problem when the session is not
visible to other FGSP members: On FGTA, the state of the session showed
'synced': FGTA # diagnose sys session filter dst 23.50.89.168FGTA #
diagnose sys session listsession info: ...
Description This article describes how to clear the old config error
logs. Note that the old config error logs will not clear by themselves,
so it is recommended to clear the old config error logs once it has been
addressed to avoid confusion that it...
Description This article describes how to change port and protocol for
Syslog setting in CLI. Scope FortiGate CLI. Solution FortiGate will use
port 514 with UDP protocol by default. In order to change these
settings, it must be done in CLI : config l...
Description This article describes how the FSSO agentless polling on the
AD server failed due to NT_STATUS_NETLOGON_NOT_STARTED error. Scope
FortiGate FSSO agentless polling on the AD server. Solution When
troubleshooting on FSSO agentless polling mo...
Hello, Welcome to Fortinet Community :) I believe this is not a good
site for you to learn more about CCSP - which is a training course from
other vendor If your question is to ask whoever that is certified CCSP
to share their own experience, then yo...
The vm models should be based on how many vCPU For your case, your
output showed : CPU: 1 (subscription:1) Then this means it will be VM-01
You may refer to the datasheets for reference :
https://www.fortinet.com/content/dam/fortinet/assets/data-shee...