Description This article outlines the steps to resolve an issue where a
FortiSwitch is not powering a GRANDSTREAM GXP2160 VoIP phone. Scope
FortiSwitch-124F, FortiSwitch-148F with RT PoE firmware versions 1.0.1.6
/ 1.0.1.7. Solution Before proceeding...
Description This article describes that in certain industrial
environments, devices using Profinet communication—specifically PTCP
(Precision Time Control Protocol) may send packets using the multicast
MAC address 01:80:c2:00:00:0e. PTCP leverages LL...
Description This article provides a simple example of a basic VLAN
stacking (QinQ) configuration terminating on a FortiSwitch. Scope
FortiSwitch v7.4, v7.6. Solution The ISP, connected to port1 of the
FortiSwitch, forwards S-VLAN 2540 and C-VLAN 1501...
Description This article outlines one possible cause for a FortiSwitch
upgrade failure initiated from the FortiGate and how to resolve the
issue. Scope FortiGate v7.4 FortiSwitch v7.2, v7.4, v7.6 Solution
Upgrade attempts for FortiSwitch via FortiGat...
Description This article explains the reason for receiving SNMP trap
alerts related to port status changes (link up/down) on FortiSwitch
devices and discusses whether it is possible to disable such alerts.
Scope FortiSwitch OS versions: 7.6.1, 7.4.6,...
Hi, I believe their is a FGT internal interface (let say port10) under
this you have vlan 50. You want to share/extend this vlan50 to fortilink
network. i.e client on FSW want to get Ip from vlan50. If the above is
true then it is not possible as the...
Hi, As I understand you are trying to setup FSW on Fortilink with Cisco
switch in between. This is not a recommended design for Fortilink L2
deployment. 1> Either you setup this FSW directly connected to FGT this
is a L2 setup. 2> Or have Cisco conne...
Hi, As mentioned in guide Queue-7 is used for network and critical
management traffic. If the FSW is managed then your Fortilink would get
affected. I would suggest avoid using that specific queue. Understanding
control traffic, refer link: QOS queue...
Hi, I understand you have 300 standalone FortiSwitches that you’d like
to transition to a managed configuration using FortiSwitch Manager. If
that’s the case, these FortiSwitches will need to be manually configured
to enable management by FortiSwitch...
Hi Jacky, Disable dhcp-snooping if enabled on vlans. If you still see
issue then provide the following logs in the TAC ticket with FSW serial
no. show full-configuration diagnose switch pdu-counters listdiagnose
debug crashlog readdiag debug report R...
