Description This article describes how to configure VRRP in a situation
where it is necessary to apply the parameter over a secondary IP
address. Scope FortiSwitch v6.x and above. Solution When VRRP is
required for a secondary IP address, a network m...
DescriptionThe FortiWAN configuration file is encrypted and the
information that it contains cannot be seen in a simple text
editor.ScopeAny FortiWAN device at any firmware version.SolutionThe
configuration file information can be obtained from the G...
DescriptionFrom version 3.5.0 it is possible to split 40G ports into
four 10G ports on following devices:FS-3032D (Port5 to port28 can be
split)FS-524D, FS-524D-FPOE (Port29 and port30 can be split)FS-548D,
FS-548D-FPOE (Port53 and port54 can be spli...
DescriptionIn the event of an ADSL connectivity failure there are some
steps which can be taken to confirm the root of the issue that has
brought the ADSL service status down.One possible cause is an actual
physical failure that sometimes cannot be d...
Description This article describes how to resolve the L4 load balance no
connectivity issue on FortiADC. Scope FortiADC.Solution The 'DNAT packet
forwarding method' only considers destination IP address translation,
keeping the source IP address in t...
Hello,I was not able to finish the lab (it never full\y load actually).
Is it possible to count with access to the lab one more time?Thank you
for your attention.Best Regards.
